ATON CLT300 Guide de l'utilisateur télécharger pdf (Page 54)

52

Appendix

Aton CLT300 - Gig S455 / swisscom-en / Internet / appendix.fm / 23.04.2007

Appendix

Care

¤ Wipe the base station and handset with

a damp cloth (do not use solvent) or an

antistatic cloth.

Never use a dry cloth. This can cause

static.

Contact with liquid

If the handset has come into contact with

liquid:

1. Switch the handset off and remove

the batteries immediately.

2. Allow the liquid to drain from the hand-

set.

3. Pat all parts dry, then place the handset

with the battery compartment open

and the keypad facing down in a dry,

warm place for at least 72 hours (not

in a microwave, oven etc.).

4. Do not switch on the handset again

until it is completely dry.

When it has fully dried out, you will nor-

mally be able to use it again.

Faults and Self-help with

Troubleshooting

Not every fault is due to a defective

phone. In certain circumstances, it can

come from a brief interruption in the

power supply to the base station (unplug/

plug in power supply) or if the batteries of

the handset are removed and inserted

again. The following instructions should

be of help for specific faults.

Important: problems or faults can only be

remedied if you bring the complete unit

(base station, handset, as well as connect-

ing cable) to the place of purchase.

!

The display is blank.

1. The handset is not switched on.

¥ Press and hold the end call key a.

2. The batteries are flat.

¥ Charge or replace the batteries (page 8).

"Base station x" is flashing in the display.

1. The handset is outside the range of the base

station.

¥ Reduce the distance between handset/

base station.

2. The handset has been de-registered.

¥ Register the handset (page 41).

3. The base station is not switched on.

¥ Check the base station mains adapter

(page 6).

Base Search is flashing in the display.

The handset is set for Best Base and no base sta-

tion is switched on or within range.

¥ Reduce the distance between handset/base

station.

¥ Check the base station mains adapter

(page 6).

Handset does not ring.

1. The ringtone is switched off.

¥ Activate the ringtone (page 47).

2. Call diversion set to All Calls.

¥ Switch off Call Diversion (page 17).

You cannot hear a ringtone/dialling tone.

Base station's phone cord has been replaced.

¥ When purchasing a new cord, ensure that it

has the correct pin connections (page 7).

The other party cannot hear you.

You have pressed the

u (INT) key. The hand-

set is "muted".

¥ Switch on the microphone again (page 14).

The incoming call number is not displayed

although CLIP is set.

Phone number identification is not working.

¥ Caller should ask network provider to check

phone number identification (CLI).

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 67 68

Commentaires sur ces manuels

Pas de commentaire